Maxgrout Non Shrink High Resistance Fluid Mortar
MAXGROUT®is a one-component nonshrink mortar formulated from special cement and well-graded mineral products which provide high mechanical properties and fluidity. Contains no chlorides or metal particles. It comes in powder form, ready to use mixing only with water.
Please ask your questions here.
ONE-COMPONENT FLEXIBLE WATERPROOF COATING AGAINST POSITIVE AND NEGATIVE PRESSURE FOR CONCRETE AND MASONRY
Anchoring of pillars in concrete prefabricated structures. Filling of steel column bases. Beam support in bridges.Anchoring of bolts, cables, etc. Filling of machinery foundation
between concrete and steel plates.Structural repair and strengthening of
damaged or weak concrete structures such as foundations, beams, pillars, etc. Repairing joints in pavements. Void-filling corrective process and consolidation under concrete slabs.
High early and ultimate strength. Very good adhesion on surfaces, it becomes a structural part of the substrate and it withstands to repeated loads. Non-shrink and slightly expansive, thus it does not lose contact with the substrate where is placed. High cohesion of the fresh mortar without segregation or bleeding.Waterproof, fireproof and non-toxic. Unaffected by extreme temperatures once set. Contains no chlorides or metal particles, it is non-corrosive for steel surfaces. Resistant to water, oil and grease.
How To Use – Application Instructions
Want to know how to use this brilliant waterproof grout sealer? Then let us help you out. We have listed the important instructions below.
Preparation: You must clean the surface off dirt, coating, efflorescences, oil & other materials. Then, you must saturate the surface with clean water.
Mixing: Mix the MAXGROUT waterproof grout sealer with water. You can use up to 3-3.5 L of water to mix a 25kg bag of this sealer. Blend the mixture till all the lumps get disappear. However, it’s essential that you do not overuse water above the given ratio.
Placing: Put the MAXGROUT directly through the container into the surface. You can also use machine pumping applications to pour the mixture onto the surface. While setting it, you should avoid cold joints and air entrapments.
However, there are a few conditions that you must adhere to while applying this waterproof grout sealer.
Weather Conditions: You should only apply this mixture when the temperature is between 10 to 25 °C. Also, avoid using it during the winters or when it’s below 5°C. Thus, you should always avoid applying MAXGROUT on frosted surfaces. Similarly, during the summer season or too windy, make sure to use cold water or iced water and store the mixture in a cold place.
Curing: As soon as you pour the sealer onto the surface, the curing procedures must begin. Use wet burlaps or rags and plastic sheeting for curing.
Cleaning: You should clean all the equipment and tools that were used with water.
Contact Scientific Waterproofing Products to know more details about this waterproof grout sealer from Drizoro!
Stop Losing Your Most Precious Asset.
Water is not only a precious commodity but also a very destructive force and the cause of many problems in the building industry.
Whether it is a problem to retain water or to protect against water damage SWPPL has an extensive range of cement based products and the expertise to provide solutions to difficult problems.
It is VITAL to not only recognize the problem but to properly diagnose and have the suitable products to provide the solution. SWPPL based on years of experience and being able to draw on a multitude of technically superior materials can provide cost effective solutions to all waterproofing problems.
SWPPL provide the largest Range of technically superior DRIZORO cementicious waterproofing products in the market place.
SWPPL will always provide the right solution to any problem.
Manufactured to a high standard DRIZORO Products supplied by SWPPL will provide longer protection and are more cost effective than most others.