Drizoro Maxrest Structural Repair Mortar
MAXREST is a one-component structural repair mortar, made of special cement, additives and selected aggregates, which provides a thixotropic product with quick-setting that does not shrink. It firmly adheres to the surface which it is applied on, and restores concrete to its original condition.
Please ask your questions here.
ONE-COMPONENT FLEXIBLE WATERPROOF COATING AGAINST POSITIVE AND NEGATIVE PRESSURE FOR CONCRETE AND MASONRY
For general repair and restoration work on structural concrete. Repairs honeycombs, cracks and fissures.Patching and protective covering of superficial reinforcing rods affected by corrosion.To repair lintels, rain caps, water tanks and to restore architectural concrete permanently exposed to climatic conditions.Sealing of construction joints prior to waterproofing works in tanks, swimming pools, basements, etc.For the restoration of lines and shapes of damaged prefabricated concrete elements.
Its quick-setting time, from 15 to 20 minutes, allows for an agile repair process.It forms part of the substrate and the repairs are structurally sound, with properties comparable to or higher than concrete.Very good thixotropy without slump or the need for using formwork.It does not shrink, avoiding the risk of cracks when it has set.Odour-free and non-toxic, making it the ideal material to use in badly ventilated places, such as water tanks, shafts, sewers, etc.Does not contain any chloride.Only needs the addition of water for mixing.
Application Instructions – How To Use MAXREST
If you want the perfect finish when you apply this structural repair mortar by Drizoro? Then you must follow the instructions provided in the brochure. You can also read the following instructions on how to use MAXREST here on this site.
Preparation: Preparing the surface before applying this structural repair mortar is essential. You need to clean the surface and make sure it’s free of grease, dirt, loose particles, etc. Similarly, remove all the damaged concrete parts of the surface as well.
Mixing: You need to mix a 25kg bag of MAXREST with clean water. You can take up to 3.5 to 4 litres of water to do so. It takes approximately 15-20 minutes for this mixture to set.
Application: Before you apply the mortar, prepare, and apply a slurry of the MAXREST on the surface that needs repair. And then, while the slurry is still fresh, place the MAXREST structural repair mortar.
You have to apply the mortar in successive layers. However, make sure to wait at least 10-15 minutes between each layer’s application.
Are There Any Conditions To Look For?
Yes, you must consider a few conditions while applying this structural repair mortar at your preferred site.
- Only apply it above 5ºC; otherwise, do not use this mortar. Avoid this procedure on frosted surfaces.
- Make sure to cure the surface with a wet cloth to protect the repair from high temperature.
- Similarly, clean all the tools used immediately once you have finished this procedure!
Need to know more? Contact Scientific Waterproofing Products today or download the brochure available on this page!
Please ask your questions here